The dimensions and prices of our most popular wind deflectors are detailed below.

The fitment of wind deflectors and spoilers to caravans and trailers is also very popular. Spoiler Factory's range of wind deflectors are designed and built in Perth, Western Australia to suit our local operating conditions and will fit most small to medium trucks on the road in Australia. Once the window has been closed, please leave it closed for 24-48 hours so that the rubber seal can mould itself to the deflector, creating more room for the window.With fuel a major expense for all transport businesses, the use of wind deflectors on commercial vehicles is smart business practice.įuel savings of at least 10 percent can be expected after installation, multiply these savings over the operating life of a vehicle and you can expect to save the cost of the wind deflector many times over. As you are gradually closing the window, you may need to gently pull the deflector outwards to allow the window to pass without triggering the sensors. Holding the button or letting the window go up automatically may trigger the anti-trap sensor and prevent the window from closing.

Finally, close the window in small increments.

Use a flathead screwdriver to push the clips into the channel. The hook/notch on the clips must be facing away from the deflector.

Once the deflector has been fitted, fit 2 clips on each end.

Starting from the mirror end use both hands to ease the milled edge of the deflector into the rest of the window channel not between the rubber and the metal frame.(Please be careful as excessive bending may snap the deflector). Push the other end of the deflector into the window channel – you may need to gently bend the deflector.( NOTE: If you place it on the soft part of the rubber the deflector will not hold under tension).

Starting with the side mirror end of the window, rest the bottom edge of the deflector on the hard rubber window seal.Remove all adhesive tape from the deflector.Wait for it to dry slightly before starting the installation.

Lubricate the milled edge of the deflector with either a silicone spray or washing up fluid.

Clean the window channel to ensure the adhesive has a clean surface to stick to.

Take care when removing from the box and fitting – some edges and corners of the deflector can be sharp.

FITTING INSTRUCTIONS FOR ELECTRIC WINDOWS WITH ANTI TRAP SENSORS

Instal Deflector